front=output/gerbers/Flow_Controller_Panel-Front.gtl
back=output/gerbers/Flow_Controller_Panel-Back.gbl
drill=output/gerbers/Flow_Controller_Panel.drl
outline=output/gerbers/Flow_Controller_Panel-Edge_Cuts.gm1

# Use the 'User-Eco1' layer instead as it contains panelized board's slot outlines only.
#outline=output/gerbers/Flow_Controller_Panel-User-Eco1.gbr

# Generic
metric=true         # use metric units for parameters
metricoutput=true   # use metric units for output
nog64=true          # do not set an explicit g64
#nom6=true           # do not emit m6
zsafe=2             # The height in mm at which the bit can move freely without obstruction
zchange=35          # Tool changing height in mm
output-dir=output/gcode

# Place a 5x7cm board in the lower right quadrant of the coordinate system
# This will allow you to probe the fixed jaw of the vise for (0,0) on the CNC.

# For two-sided boards, the PCB needs to be flipped along the axis x=VALUE
mirror-axis=80      # set this to half of your board width

# Drilling
zdrill=-2.2         # drilling depth
drill-feed=400      # Vertical mm/min feed
drill-speed=24000   # Spindle RPM
#onedrill=true       # Use a single drill for all holes
nog81=true          # replace G81 with G0+G1 (no G81 in GRBL)
drill-side=back

# Milling
zwork=-0.1          # V-bit plunge depth
#mill-diameters=0.11 # 60 deg V-bit dia at -0.1 plunge depth
#mill-diameters=0.08 # 45 deg V-bit dia at -0.1 plunge depth
mill-diameters=0.05 # 30 deg V-bit dia at -0.1 plunge depth
mill-speed=24000    # Spindle RPM
mill-feed=600       # Horizontal feedrate in mm/min
mill-vertfeed=100   # Plunge rate in mm/min
voronoi=true        # cuts the milling time significantly, but check with this on and off if everything looks ok
preserve-thermal-reliefs = true # has effect only if voronoi=true

# Cutting
zcut=-4
cutter-diameter=2.1
cut-feed=400
cut-vertfeed=50
cut-infeed=4
cut-speed=24000
cut-side=back

# Tabs
#bridgesnum=4        # Total 4 tabs
#bridges=0.5	    # Tab width 0.5 mm
#zbridges=0	    # bridges height (default to zsafe)
