initial

millproject

@@ -0,0 +1,55 @@
+front=output/gerbers/Flow_Controller_Panel-Front.gtl
+back=output/gerbers/Flow_Controller_Panel-Back.gbl
+drill=output/gerbers/Flow_Controller_Panel.drl
+outline=output/gerbers/Flow_Controller_Panel-Edge_Cuts.gm1
+
+# Use the 'User-Eco1' layer instead as it contains panelized board's slot outlines only.
+#outline=output/gerbers/Flow_Controller_Panel-User-Eco1.gbr
+
+# Generic
+metric=true         # use metric units for parameters
+metricoutput=true   # use metric units for output
+nog64=true          # do not set an explicit g64
+#nom6=true           # do not emit m6
+zsafe=2             # The height in mm at which the bit can move freely without obstruction
+zchange=35          # Tool changing height in mm
+output-dir=output/gcode
+
+# Place a 5x7cm board in the lower right quadrant of the coordinate system
+# This will allow you to probe the fixed jaw of the vise for (0,0) on the CNC.
+
+# For two-sided boards, the PCB needs to be flipped along the axis x=VALUE
+mirror-axis=80      # set this to half of your board width
+
+# Drilling
+zdrill=-2.2         # drilling depth
+drill-feed=400      # Vertical mm/min feed
+drill-speed=24000   # Spindle RPM
+#onedrill=true       # Use a single drill for all holes
+nog81=true          # replace G81 with G0+G1 (no G81 in GRBL)
+drill-side=back
+
+# Milling
+zwork=-0.1          # V-bit plunge depth
+#mill-diameters=0.11 # 60 deg V-bit dia at -0.1 plunge depth
+#mill-diameters=0.08 # 45 deg V-bit dia at -0.1 plunge depth
+mill-diameters=0.05 # 30 deg V-bit dia at -0.1 plunge depth
+mill-speed=24000    # Spindle RPM
+mill-feed=600       # Horizontal feedrate in mm/min
+mill-vertfeed=100   # Plunge rate in mm/min
+voronoi=true        # cuts the milling time significantly, but check with this on and off if everything looks ok
+preserve-thermal-reliefs = true # has effect only if voronoi=true
+
+# Cutting
+zcut=-4
+cutter-diameter=2.1
+cut-feed=400
+cut-vertfeed=50
+cut-infeed=4
+cut-speed=24000
+cut-side=back
+
+# Tabs
+#bridgesnum=4        # Total 4 tabs
+#bridges=0.5	    # Tab width 0.5 mm
+#zbridges=0	    # bridges height (default to zsafe)