56 lines
2.0 KiB
Plaintext
56 lines
2.0 KiB
Plaintext
front=output/gerbers/Flow_Controller_Panel-Front.gtl
|
|
back=output/gerbers/Flow_Controller_Panel-Back.gbl
|
|
drill=output/gerbers/Flow_Controller_Panel.drl
|
|
outline=output/gerbers/Flow_Controller_Panel-Edge_Cuts.gm1
|
|
|
|
# Use the 'User-Eco1' layer instead as it contains panelized board's slot outlines only.
|
|
#outline=output/gerbers/Flow_Controller_Panel-User-Eco1.gbr
|
|
|
|
# Generic
|
|
metric=true # use metric units for parameters
|
|
metricoutput=true # use metric units for output
|
|
nog64=true # do not set an explicit g64
|
|
#nom6=true # do not emit m6
|
|
zsafe=2 # The height in mm at which the bit can move freely without obstruction
|
|
zchange=35 # Tool changing height in mm
|
|
output-dir=output/gcode
|
|
|
|
# Place a 5x7cm board in the lower right quadrant of the coordinate system
|
|
# This will allow you to probe the fixed jaw of the vise for (0,0) on the CNC.
|
|
|
|
# For two-sided boards, the PCB needs to be flipped along the axis x=VALUE
|
|
mirror-axis=80 # set this to half of your board width
|
|
|
|
# Drilling
|
|
zdrill=-2.2 # drilling depth
|
|
drill-feed=400 # Vertical mm/min feed
|
|
drill-speed=24000 # Spindle RPM
|
|
#onedrill=true # Use a single drill for all holes
|
|
nog81=true # replace G81 with G0+G1 (no G81 in GRBL)
|
|
drill-side=back
|
|
|
|
# Milling
|
|
zwork=-0.1 # V-bit plunge depth
|
|
#mill-diameters=0.11 # 60 deg V-bit dia at -0.1 plunge depth
|
|
#mill-diameters=0.08 # 45 deg V-bit dia at -0.1 plunge depth
|
|
mill-diameters=0.05 # 30 deg V-bit dia at -0.1 plunge depth
|
|
mill-speed=24000 # Spindle RPM
|
|
mill-feed=600 # Horizontal feedrate in mm/min
|
|
mill-vertfeed=100 # Plunge rate in mm/min
|
|
voronoi=true # cuts the milling time significantly, but check with this on and off if everything looks ok
|
|
preserve-thermal-reliefs = true # has effect only if voronoi=true
|
|
|
|
# Cutting
|
|
zcut=-4
|
|
cutter-diameter=2.1
|
|
cut-feed=400
|
|
cut-vertfeed=50
|
|
cut-infeed=4
|
|
cut-speed=24000
|
|
cut-side=back
|
|
|
|
# Tabs
|
|
#bridgesnum=4 # Total 4 tabs
|
|
#bridges=0.5 # Tab width 0.5 mm
|
|
#zbridges=0 # bridges height (default to zsafe)
|