46 lines
1.6 KiB
Plaintext
46 lines
1.6 KiB
Plaintext
back=Step_Down_Carrier_Board-B_Cu.gbr
|
|
drill=Step_Down_Carrier_Board-PTH.drl
|
|
#drill=Step_Down_Carrier_Board-NPTH.drl
|
|
# outline=Step_Down_Carrier_Board-Edge_Cuts.gbr
|
|
|
|
# Generic
|
|
metric=true # use metric units for parameters
|
|
metricoutput=true # use metric units for output
|
|
nog64=true # do not set an explicit g64
|
|
nom6=true # do not emit m6
|
|
zsafe=2 # The height in mm at which the bit can move freely without obstruction
|
|
zchange=35 # Tool changing height in mm
|
|
output-dir=gcode
|
|
|
|
# Place a 5x7cm board in the lower right quadrant of the coordinate system
|
|
# This will allow you to probe the fixed jaw of the vise for (0,0) on the CNC.
|
|
|
|
mirror-axis=35.5 # set this to half of your board width
|
|
|
|
# Drilling
|
|
zdrill=-2.5 # drilling depth
|
|
drill-feed=200 # Vertical mm/min feed
|
|
drill-speed=24000 # Spindle RPM
|
|
onedrill=true # Use a single drill for all holes
|
|
nog81=true # replace G81 with G0+G1 (no G81 in GRBL)
|
|
|
|
# Milling
|
|
zwork=-0.1 # V-bit plunge depth
|
|
#mill-diameters=0.11 # 60 deg V-bit dia at -0.1 plunge depth
|
|
#mill-diameters=0.08 # 45 deg V-bit dia at -0.1 plunge depth
|
|
mill-diameters=0.05 # 30 deg V-bit dia at -0.1 plunge depth
|
|
mill-speed=24000 # Spindle RPM
|
|
mill-feed=600 # Horizontal feedrate in mm/min
|
|
mill-vertfeed=100 # Plunge rate in mm/min
|
|
voronoi=true # cuts the milling time significantly, but check with this on and off if everything looks ok
|
|
preserve-thermal-reliefs = true # has effect only if voronoi=true
|
|
|
|
# Cutting
|
|
# zcut=-2.5
|
|
# cutter-diameter=2
|
|
# cut-feed=80
|
|
# cut-infeed=100
|
|
# cut-speed=24000
|
|
# cut-side=back
|
|
|